2015-19 4WD Tahoe, Yukon 1500 (aluminum, stamped steel) 6.5" knuckle lift kit, Shadow Nitro shocks

This Superlift 6.5" Knuckle Version lift kit for the Tahoe and Yukon 1500 includes replacement steering knuckles to span the increased distance between the control arms. Spacers that install on top of the factory coilover assembly provide front lift. Pre-load rings slightly increase spring rate to help offset additional loads and firms up what would otherwise be a "spongy" ride. The factory lower control arms and axle housing are lowered while the upper control arms are retained and remain in their original location.

Pre-set coil springs provide rear lift. Included are relocation brackets for the factory 4-link setup and rear Superide shocks. Expect to experience optimal component service life along with exceptional drivability due to Superlift's geometry design from steering timing, linkage angles, driveshaft and CV axle operating angles.

• Replacement cast ductile iron knuckles
• Differential skid plate
• High clearance, one piece crossmembers made of 1/4" steel
• Rear relocation brackets for factory 4-link
• Rear coil springs
Rear Shadow Nitro shocks (included but not shown)
• Limited Lifetime Warranty and Satisfaction Guarantee